Using the List Volume command, you can make sure that the volume is formatted and a letter is assigned to it.

You can do this by typing the following commands: The last thing we have to do is format the volume and assign it a letter. Please note that each volume is assigned a number. Now that we have converted our drives, we can create a RAID 5 volume by entering the following commands:īy entering the List Volume command, you will verify that the RAID volume has been created. Assuming that none of the disks are dynamic, you can convert them from basic to dynamic by entering the following commands: If you look at the picture, you can see that the List Disk command displays whether the disk is dynamic or not. We also assume that drive 0 is our system drive, and drives 1, 2, and 3 are empty hard drives that we want turn in RAID 5 volume.īefore we can create a RAID 5 volume, we need to make sure that each of the disks is connected as a dynamic disk. For example, your system has 4 hard drives, and these hard drives are numbered 0, 1, 2, and 3. In many cases, disk management includes the creation of fault-tolerant volumes, and you can easily create them using the Diskpart command. For example, to perform an operation with disk 0, you need to type Select Disk 0. If you need to perform operations with a specific disk, you must specify the disk by entering the Select command. Pay attention to the above picture, it shows that each disk is assigned a number. After entering this command, Windows will display a list of all physical disks installed on the server. In this example, List is a verb, and Disk is a noun. One of the simplest examples of Diskpart commands is the List Disk command.

The verb says what actions to perform, and the noun indicates the object with which you want to perform the action. A typical Diskpart command consists of a verb and a noun.

Windows disk management command